The reassurance of a trustworthy brand
Raychem
ramp heating systems are known for their long life and quality. We offer a
5-year warranty on complete heating systems. To benefit from the warranty you
must register your installation by sending us the commissioning report that is
included in every shipment, or downloadable in the beneath installation details.
Installation Information for:
EM2-XR
Self-Regulating heating cable for reinforced concrete-ramps
EM2-MI
Mineral insulated, high temperature resistant heating cable for asphalt ramps
EM2-CM
Pre-terminated constant wattage heating mat for ramp, pavement and track heating
EM4-CW
400V Pre-terminated constant wattage heating cable for larger concrete areas and stairs
EM2-XR
 |
The heating cable can be cut-to-length on site. It also allows for narrow
spacing: typically at expansion joints, card readers and wheel blocking
systems. Self-regulating cable cannot overheat or burnout - even in air gaps.
Its thick outer jacket withstands tough installation conditions e.g. during the
concrete pour.
DOWNLOAD installation instructions and test report |
Power output varies with spacing & installation
Configured heating units comprising EM2-XR cable and accessories:
 |
To provide even greater time savings on-site, the robust and powerful EM2-XR cable can be provided as a configured heating unit, complete with power cable and installed terminations.
Tyco Thermal Controls will manufacturer the complete unit - pre-install the cold lead, splice and end seal - ready for immediate installation on site.
Contact your local customer service representative for quotation enquiries or further technical information, based on:
- The heater length required.*
- The cold lead length required.*
(* Within the design parameters of the product.)
|
EM2-MI
 |
- Pre-terminated heating mat requires no onsite cold lead or end seal connections
- Heating cable can be fixed to an existing reinforcement bar or with fixing strips from Tyco Thermal Controls
DOWNLOAD
installation instructions and test report |
EM2-CM
 |
- Pre-terminated heating mat requires no onsite cold lead or end seal connections
- Heating mat can be simply rolled out over the required surface prior to the cement pour.
- No need to measure cable spacing to ensure a consistent heat output per m2 - the mat has a pre-determined fixed heat output of 300W/m2.
DOWNLOAD
installation instructions and test report |
EM4-CW
 |
- Pre-terminated heating cable requires no onsite cold lead or end seal connections
- Heating cable can be fixed to an existing reinforcement bar or with fixing strips from Tyco Thermal Controls
DOWNLOAD
installation instructions and test report |
|
